Is there any way to stop the temp osc on the oven.I've used a TC type J to measure the temp and just like Samsung says ,the oscillation between any setpoint is 20-30 degrees. I've worked in manufacturing for many years and would like to know if there's a way to change the tuning parameters in the PID control loop. I'm not asking for anything precise ,but +/- 5 degrees or even 10 degrees would be a big improvement.
Hello! Thank you for reaching out! Unfortunately, as we are not technicians we would be unable to offer any advice on this. If you would like you may be able to purchase a service manual from the samsungparts.com website. Please note that any self-repair/DIY changes to the normal functions will prevent warranty repairs if so needed.
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
Hello! Thank you for reaching out! Unfortunately, as we are not technicians we would be unable to offer any advice on this. If you would like you may be able to purchase a service manual from the samsungparts.com website. Please note that any self-repair/DIY changes to the normal functions will prevent warranty repairs if so needed.
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
