Original topic:

Z-wave Repair

(Topic created on: 2/25/21 9:05 PM)
BradRay
Astronaut
Options
Smart Home Support

I am trying to setup Z-wave switches (Zooz brand) and I am having a lot of issues getting the z-wave repair to function correctly.  I get errors such as these when running the z-wave repair utility:

Network repair for Hallway Bathroom Light [1D]: Could not update neighbors

Network repair for device [13]: Could not assign new route

Network repair for Master Bathroom Light [14]: Could not delete old routes

 

What can I do to fix these?   I have already tried doing the z-wave "Exclusion" and then "inclusion again".  If the exclusion fails, then I have deleted the device from Smartthing IDE then performed a factory reset on the switch, the re-added (included) it.  Is there something else I need to do to get it to complete go away to start over?  some of the device numbers listed in the errors are active devices in my smartthing IDE device list.

0 Likes
Reply

1 Solution


Accepted Solutions
Solution
SamsungLou
Samsung Moderator
Samsung Moderator
Options
Smart Home Support

Please reach out directly to our SmartThings support team for assistance at 866-813-2404, or via email at support@smartthings.com.


Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.





Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.

View solution in context

1 Reply
Solution
SamsungLou
Samsung Moderator
Samsung Moderator
Options
Smart Home Support

Please reach out directly to our SmartThings support team for assistance at 866-813-2404, or via email at support@smartthings.com.


Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.





Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.

View solution in context