After thoroughly cleaning and reattaching the ductwork, the "ductwork clogged" symbol won't go away. Keeps coming on towards the end of the drying cycle. Any suggestions?
Just to make sure, did you also clean the ductwork system in the house or building? I would also suggest resetting the circuit breaker if you haven't done that already.
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
Thank you for responding. I reset the circuit breaker as you suggested and it appears to have worked. Just solely unplugging the dryer for ten minutes did not work. Thank you for your help. Much appreciated.
Well I still appreciate your help, but unfortunately after one cycle of drying, the ductwork clogged symbol has come back on. Tried turning the circuit breaker back off again and cleaned off the sensor the humidity sensor in the lint basket, but no help. Any other ideas?
The dryer is going to need service then. I'll be happy to set that up for you! Feel free to send me a private message with the serial number of the dryer. http://bit.ly/2sSxapD
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
