The normal setting of 45 minutes has been taking longer. A periodic 3C code shows. Unlocks and stops at 35min left. 26 min left. Push start go a bit more then stops. Have turned off machine and restarted, runs normal, then throws 3C. Check hose for blockage-none. Currently have rotor and stator off, planning to check stator static resistance. I do not have clear direction on which part to chase as the problem.
Hello! I completely understand your frustration with the washer not completing a cycle. I'll be more than delighted to assist with this issue. If your washer is a front load machine. There is a pump filter on the front of the machine located in the bottom left or right-hand corner. Once you open the door of the filter begin to drain that hose. Once all water is out close it back up and try starting the cycle again.
If you're still experiencing this issue, the unit will require service. If the unit is under warranty, please feel free to send any moderator a message for service options. You can use this link to locate a service center in your area to do the repair. http://www.samsung.com/us/support/service/location.
Hello! I completely understand your frustration with the washer not completing a cycle. I'll be more than delighted to assist with this issue. If your washer is a front load machine. There is a pump filter on the front of the machine located in the bottom left or right-hand corner. Once you open the door of the filter begin to drain that hose. Once all water is out close it back up and try starting the cycle again.
If you're still experiencing this issue, the unit will require service. If the unit is under warranty, please feel free to send any moderator a message for service options. You can use this link to locate a service center in your area to do the repair. http://www.samsung.com/us/support/service/location.
