When I try to put it in a wash cycle, the door locks, the machine adds some cold water, then it does nothing but shows four spinning lights where the time left would be or an error code would display. I have looked at error codes in the manual but nowhere is the spinning lights mentioned. I have reset the breaker, I have cleaned the drains, I have ensured the drain pipe is clear and flowing. Please advise!
I am sorry to hear about this. Does this happen in all cycle selections? Have you tried running a Calibration on the washing machine?
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.