Original topic:

WA4J7700AW/A2 Washer stops after filling with water

(Topic created: 4 weeks ago)
Washers and Dryers

I just had to replace the transmission in my washer and when running it for the first time, the washer will fill up with water just fine, but then it stops immediately after starting the agitation cycle.

I did receive  a clutch position not detected error code, but I checked the clutch and everything looked correct and the wiring harnesses were all connected properly.  I cycled power and haven't had the error code return.

I checked the door switch and it all checks out.  Voltage was around 7.2 V DC.

The pressure switch hose is attached and I am assuming that it is working properly since the water filling cycle stops at the appropriate level.

Any ideas what may be causing the issue.

0 Replies