cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Constellation

Washer runs 2 minutes then stops error code 4E

4 year old Samsung front load washer WF42H5000AW/A2 starts and fills normally, runs 2 minutes, then stops and gives error code 4E

It does the same thing even when empty.

3 REPLIES 3
Highlighted
Samsung Moderator
Samsung Moderator

Re: Washer runs 2 minutes then stops error code 4E

The 4E error code displays the water is not entering the washer correctly. Have you cleaned out the pump filter located on the bottom left-hand corner of the washer?

 

  1. Make sure the hot and cold water supply hoses are connected to the correct inlets n the washer, that the hoses are not bent or kinked, and that the washer supply valves are completely open.
  2.  Unplug the washer or flip the circuit breaker for the washer for 1 min and try to run a cycle.

 


Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.

Reply
Loading...
Highlighted
Constellation

Re: Washer runs 2 minutes then stops error code 4E

Same problem, 5 years old washer, runs for 3 minutes, fills up the water, starts, but then gives the error 4e..rinse and spin works. Self cleaning also stops after some 20minute with same error. have checked all hardware possibilities, all works. The main motherboard unit was replaced 1 year ago due to some other error.

Reply
Loading...
Highlighted
Samsung Moderator
Samsung Moderator

Re: Washer runs 2 minutes then stops error code 4E

Make sure that you've cleaned and drained the debris filter at the front bottom of the washer, if that doesn't work, service would be recommended. You can use the following link to locate a service center near you: https://www.samsung.com/us/support/service/locations/.


Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.





Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.

Reply
Loading...