My wife has hated this washer since we got it. Sometimes it works correctly but most often not. It runs on and on with rinse and spin for hours. I have to shut it off and usually put it on the quick wash setting to get it to finish. I saw in your notes that there might be air in the lines. No air! Also reset the machine by unplugging the power and holding the start/ pause button for ten seconds. Neither fixed this issue. She wants it thrown in the ditch but as a life long mechanic I'm sure there must be a cure? Is there any recalls on this washer on this problem? Is there a fix for this issue? Thanks, Frank Ward
@uservqIRKUcZta Try giving these troubleshooting steps a shot and see if they work out for you 🙂 If you would like to see if your washer is affected by our top load washer recall, give the recall department a call at 1-866-264-5636 and provide them with your full model and serial number.
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
My washer wont finish its cycle because on the final spin. It starts knocking around off balance. I've opened it up and noticed the bumper pads on the sides was wore off. So i added some new ones. Not sure how to but, I just put them where the old ones where. Now on the final spin it almost can finish but not quite. So im wondering if there's a certain alignment/adjustment for the bumper pads? Or whats my problem? Bearings seem to be good. Please help my laundry is getting ridiculous...
