JUMP TO SOLUTION Solved

Original topic:

Issues with odyssey ark stand

(Topic created: 11-27-2022 03:45 PM)
3984 Views
Jahodac
Constellation
Options
Monitors and Memory

I'm trying to tighten the screws on the top of the stand into the back of monitor and no matter what I do they will not tighten. I'm thinking the screws aren't long enough to go in all the way. So, the monitor is only connected via the hooks. Has anybody experienced this or is there a trick to getting them in? Will the monitor be fine without them?

 

 

1 Solution


Accepted Solutions
Solution
defmetal
Asteroid
Options
Monitors and Memory

Yes I had this issue.  It's solution was based on the position of the TV.  I initially tried to do it while the TV was laying flat on the ground (well, its curved but you know what I mean). What I found was that this was slightly bending the frame ... very slightly, and that causes the screw holes to shift just enough to not screw in.

You have to do exactly what the directions say and install the stand while it's on the foam, or whole holding the monitor sorta.  Basically the positions shift with the frame itself and its not fun.

View solution in context

1 Reply
Solution
defmetal
Asteroid
Options
Monitors and Memory

Yes I had this issue.  It's solution was based on the position of the TV.  I initially tried to do it while the TV was laying flat on the ground (well, its curved but you know what I mean). What I found was that this was slightly bending the frame ... very slightly, and that causes the screw holes to shift just enough to not screw in.

You have to do exactly what the directions say and install the stand while it's on the foam, or whole holding the monitor sorta.  Basically the positions shift with the frame itself and its not fun.