- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā11-18-2024
01:34 PM
(Last edited
ā11-20-2024
02:10 PM
by
Samsung_Stephan
So I got some water damage on my tablet, the screen was broken since water seeped into the under layers and I had to replace it, I noticed it wasn't letting me draw so I replaced the Wacom ribbon since corrosion had borked the resistance in one of the pins. Now it was working, or so I thought, and finally glued it back together.
As you can see below there's a big sensitivity jump in the middle, and before you suggest it, no I dont use a magnetic case, never have, any ideas? I want suggestions before I go ahead and order the replacement Wacom board, that's my suspected culprit
ā
ā
ā
ā
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā11-19-2024 08:26 PM in
Tablets- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā11-20-2024 09:17 AM (Last edited ā11-20-2024 09:18 AM ) in
TabletsPretty sure I asked what component directly affects reading of the pen by the digitizer, believe it or not, I'm aware that water has gotten everywhere and components have been damaged.
I'm at the stage of damage identification and board repair now
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā11-20-2024 09:38 AM in
Tablets- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ā11-20-2024 10:02 AM in
TabletsCould be, though this is a new OEM screen that came with a new digitizer since the old one was damaged. If it continues I may get another one and see if it helps