JUMP TO SOLUTION Solved

Original topic:

When to change to AHCI when cloning to 870 Evo

(Topic created: 06-01-2021 11:16 PM)
4891 Views
Evingman
Asteroid
Options
Monitors and Memory

Hi,

About to upgrade to an Evo 870 from a four year old SSHD. The PC is an old Dell 580 MT which has a SATA II Motherboard & is set to IDE right now. 

My question is, can I switch to AHCI AFTER the 870 is cloned, but before I swap the present drive out, or must the swap to AHCI be done BEFORE cloning?

Thanks in advance for any advice!

0 Likes
Reply

1 Solution


Accepted Solutions
Solution
Anonymous
Not applicable
Options
Monitors and Memory
5 Replies
Anonymous
Not applicable
Options
Monitors and Memory
Is there a compatible mode?
Keep the target outside
Use clonezilla
0 Likes
Reply
Evingman
Asteroid
Options
Monitors and Memory

Thanks for the Reply.

The Evo would be outside attached via a SATA III to USB 3.0 cable

I was intending to use the Samsung Migration Software for the cloning - is there a reason that Clonezilla would be better?

Not sure what you mean by "compatible mode".

0 Likes
Reply
Anonymous
Not applicable
Options
Monitors and Memory
You can use your software
Compatible mode is an option next to ahci
0 Likes
Reply
Evingman
Asteroid
Options
Monitors and Memory

Ah, OK. I checked in BIOS & only ATA & AHCI are offered there.

0 Likes
Reply
Solution
Anonymous
Not applicable
Options
Monitors and Memory
Then ahci