- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-24-2021 10:44 AM in
Home TheaterHi, I recently bought the q600a soundbar, as I get it I applied the latest firmware version available Version 1002.5 (2021-10-29), the problem is that the subwoofer consumes 27W in standby and does not change...
Has anyone else measured the standby consumption of a samsung sound bar? the problem is in the consumption of the subwoofer, the bar does not have the problem....
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-24-2021 02:29 PM in
Home TheaterGood afternoon, I will be happy to assist you. Have you tried to initialize the soundbar and re-pair the subwoofer?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-24-2021 02:53 PM in
Home TheaterYes but i get the same result, the subwoofer always make the same consumption, turned on or turned off (stand-by) when the back side led turn red when the bar is turned off.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
11-29-2021 01:02 PM in
Home TheaterI would like to look a bit further into this for you! Can you send a private message to any of the mods here with the full model and serial number?
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.