JUMP TO SOLUTION Solved

Original topic:

How do I run calibration on front load washer WW25B6900AW

(Topic created: 02-08-2024 12:56 PM)
1908 Views
Morac
Constellation
Options
Washers and Dryers

I bought and just set up a WW25B6900AW front loader washer and the manual states that as part of the setup it does a calibration.   I was not asked to do a calibration after choosing my language.  It went right to the tutorial.

How can I run the calibration?

Also the tutorial always displays every time I turn on the washing machine even though I already completed it.  How can I stop it from showing every time?

 

Morac_0-1707414806236.png

 

0 Likes
Reply
1 Reply
Solution
Morac
Constellation
Options
Washers and Dryers

Never mind I found the instructions on page 44.  I'm not sure why it didn't ask to do calibration when I set it up though: 

 

Calibration

You can run calibration again for accurate weight detection.

1. Tap and hold Options for 3 seconds.

2. Turn the Navigation dial to select Calibration, and then tap OK.

- Calibration does not start if the door is not closed properly.

- The drum rotates clockwise and anticlockwise for about 3 minutes.

3. When calibration is complete, the “Calibration complete” message appears on the display and the

washer turns off automatically.