Hi, my washer won’t run. I originally thought that I over loaded the washer when I got an error code E3 so I took some stuff out and tried to run it again. I got the code again so I took everything out and tried to run it again. Still getting error code. Does anyone know how to fix this?
I just replaced my stator motor and bell sensor which is what a technician said was giving me a motor error code. My washer is having the same problem still. It will get to the rinse and spin cycle at 8 mins, work down to 4 mins and repeat the cycle over and over until I turn off the machine. How can I fix this? Do I need to reset the codes? Can I factory reset the machine? Some times it doesn’t even spin to full speed and the cloths stay soaked and I have to ring them out before putting in the dryer. I look forward to your response. @samsung
I go to start the washer, it makes some clicking sounds attempts to drain, the pump starts, then just sits there and does nothing. The wash, rinse, and spin lights are light (which I find odd). Tried unplugging, etc. Not sure where to trouble shoot first.
Anyone have any thoughts?
When I start a load my washer will either repeat the wash cycle or repeat the spin cycle. If it does it when it is at the wash cycle it adds the water and then my washer will beep and then drain the water and add new water. For the spin cycle it will add water and never get to where it actually spins, it will drain the water and continue to add water. It was only doing this once in a while now it is every load. I have only had this washer for four years. I would like to know what to do to fix this problem. It seems like a lot of people are having similar problems with their washers.