- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎02-16-2019
11:02 PM
(Last edited
‎08-15-2019
02:43 PM
by
Samsung_Stephan
My wife has hated this washer since we got it. Sometimes it works correctly but most often not. It runs on and on with rinse and spin for hours. I have to shut it off and usually put it on the quick wash setting to get it to finish. I saw in your notes that there might be air in the lines. No air! Also reset the machine by unplugging the power and holding the start/ pause button for ten seconds. Neither fixed this issue. She wants it thrown in the ditch but as a life long mechanic I'm sure there must be a cure? Is there any recalls on this washer on this problem? Is there a fix for this issue? Thanks, Frank Ward
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
‎01-18-2021 11:52 AM in
Washers and DryersWith this being a front load washer, have you cleaned and drained the debris filter and emergency hose?
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎01-19-2021 05:15 PM in
Washers and DryersThanks, I looked at this today. The filter was very clean. The emergency hose does not seem to be issue either.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
‎01-21-2021 10:56 AM in
Washers and DryersThis is going to require service as the troubleshooting steps didn't work. You can use the following link to locate a service center near you: https://www.samsung.com/us/support/service/locations/
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎05-10-2020 10:38 AM in
Washers and DryersWA52M7750AW Stuck in spin cycle. Load is not out of balance - Machine is level - I have recalibrated.
It gets down to about 5 min Ur code and goes back to rinse and will run all day. This unit is only 1-1/2 years old. Very frustrating.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
‎05-10-2020 11:02 AM in
Washers and DryersHave you tried to unplug the unit 3-5 mins or turn it off by the circuit breaker? Please feel free to send me a private message with your full model number. I would love to look into this further for you. http://bit.ly/2tCGnGK
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎12-09-2020 10:30 AM in
Washers and DryersHi, I own the same samsung washer activewash steam smartcare VRT plus model # WA52M7750A/WA62M7755A what should I do to fix this? Can you please help me? 🤔🤔🤔
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
‎12-09-2020 12:59 PM in
Washers and DryersI would be more than happy to assist with this. Could you send me a private message with your full model and serial number? http://bit.ly/2ihPL97
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎06-25-2020 06:41 AM in
Washers and DryersDid you ever get resolution to this issue? I have the same model with the same problem...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
‎09-30-2020 11:54 AM in
Washers and DryersMy front load wahser runs down to 4 minutes then jumps up to 9 minutes and repeats. Sometimes it just gets plain stuck and wont wash or spin. No codes appear. What can i do I barely purchased 14 months ago and already out of warranty.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
‎09-30-2020 05:08 PM in
Washers and DryersI'm sorry to hear that, have you had a chance to try the troubleshooting steps in the link below?
https://www.samsung.com/us/support/troubleshooting/TSG01000997/
If the troubleshooting steps did not help above then you have a couple of options based on your warranty.
- If your unit was recently purchased, you can check with your retailer on their return/exchange processes.
- If you have an extended warranty you can reach out to them to have service set up.
- If you're within the one year warranty, you can Private message me or one of our moderators with your full model and serial number to have service setup
- If you're OUT of warranty, you can use this link below to find a service center in your area.
https://www.samsung.com/us/support/service/locations/
Be sure to click " ✓ Accept as Solution" when you find an answer that works for you.
Please note, notification emails are a DO NOT REPLY address, you must log-in on the community page in order to respond.